powersoft X4 - Front Panel Interface; Power Controls (On;Off, Mute)

INDEX
13
X4 | SERVICE MANUAL
7.2 Removing the Amplifier’s Cover
(Fig. 4)
(Fig. 1)
(Fig. 5)
(Fig. 6)
By means of a T20 Torx Screwdriver, remove the 4 screws
highlighted on (Fig. 4)
Remove the front panel by unscrewing the two highlighted
Hex screws with a 6 mm Hex Screwdriver. (Fig. 1)
By means of a T10 Torx Screwdriver, remove the screw
highlighted on (Fig. 6).
By means of a Long Nose Pliers, remove the Plastic Snap
Rivet highlighted on (Fig. 5)
7. Disassembling Instruction
7.1 Removing the Front Panel
By means of a T10 Torx Screwdriver, remove all 3 screws
highlighted on (Fig. 2)
Unplug all four cables portrayed on (Fig. 3).
(Fig. 2)
(Fig. 3)
7.3 Removing the Wi-Fi Module
Locate the Wi-Fi module on the left side of the front panel.
Gently pull the Wi-Fi Module outwards and remove it
from its slot. (Fig. 7)
(Fig. 7)
Remove the lter and soak it in a mild soap and cold water solution, rinse it and let it dry thoroughly.
Front Panel Cover Complete Assembly