powersoft X4 - Final Checklist

45
X4 | SERVICE MANUAL
Once the Discovery Phase is complete (10 seconds) the square
will turn Green. Double click on the Unit to continue the test.
Apply a 1KHz 1Vpp audio signal to CH1
Check for presence of the signal in all the other channel’s VMeters
Apply a 1KHz 1Vpp audio signal to CH1
Check for presence of output signal in all channels.
Peak Current: 43.46 +/- 5%
RMS Current: 30.46 +/- 5%
Repeat this procedure by connecting the PC to the other ETH port on the unit’s SLOT Board
13
15 16
14
Function
Generator
Input 1
INDEX
Use the following list as a checklist once the amplier has been successfully repaired.
1. The Device operates on all Mains congurations
2. The front LEDs operate correctly
3. Ethernet communication
4. Discovery
5. Correct Armonìa communication
6. Input signal present on all channels
7. Output signal present on all channels
8. Armonìa displays correct meter readings on all channels
9. The fans operate accordingly to the ampliers’s status
19. Final Checklist
IT IS CURRENTLY NOT POSSIBLE TO UPGRADE FROM A NON-DANTE AMP TO A DANTE ENABLED AMP AND VICE-VERSA