powersoft X4 - Page 44

44
X4 | SERVICE MANUAL
Click on Apply, and click on OK
The Unit and its Serial Number should appear within 5 seconds
Drag and drop the unit into the Workshop, notice the ‘white/red
square around the unit, this happens while Armonia is discovering
with the unit
Click on the “Arrow” and Double Click on the Amplifier Double Click on the Matrix Area
Once the Discovery Phase is complete (10 seconds) the square
will turn Green. Double click on the Unit to continue the test
By hover the mouse cursor on top of the unit’s icon, it is possible
to check the Model, Serial, Retel(IP Address), Firmware
Click on “Match” and click on “Discovery”
5
7
9
6
10
8
11
12
INDEX