INDEX
17
X4 | SERVICE MANUAL
7.9 Removing the Slot Ethernet Board
By means of a Torx T10 Screwdriver, remove the two
screws highlighted on (Fig. 17).
Gently pull the Slot Ethernet Board outwards, removing
it from its slot.
Removed Dante Board
Removed Slot Ethernet Board with Dante Board Installed
(Fig. 17)
Note: After replacing of Dante Board, DO NOT apply pressure OR Press on the Center of the Dante Board
7.10 Removing the Dante Board
Carefully extract the Slot Ethernet Board
7.11 Removing the DIGI and ADLINK Boards
(Fig. 19)
(Fig. 20)
ADLINK BOARD
Remove the X Front LED Panel. (Fig. 18)
Remove both Audio Modules.
Remove the Slot Ethernet Board
Unplug the Flat Cable portrayed on (Fig. 19).
Unscrew the two Phillips Head Screws Highlighted on
(Fig. 20).
Gently lift and extract the DIGI/ADLINK Boards
NOTE: Extract the battery from the ADLINK Board if replacement is necessary.
(Fig. 18)
To Next Page
Loading...
