24
WLAN Configuration in Windows
Make sure the Wireless LAN module is turned on (and not
in Airplane Mode) before configuration begins.
1. Click the icon in the notification area of the taskbar.
2. A list of available access points will appear.
3. Double-click an access point to connect to it (or click it and click
Connect).
4. Enter a network security key (password) if required, and click
Next.
5. You can choose to find other devices or not.
6. When you are connected to the network access point it will
display Connected.
7. Select any connected network and click Disconnect to
disconnect from a connected access point.
8. You can click the Airplane Mode button to turn the mode On or
Off.
9. Alternatively you can click the Wi-Fi button to turn just the Wi-Fi
On or Off.
Wireless Display
Miracast uses your Wireless LAN (WLAN) module to al-
low you to display the contents of the notebook display on
another display such as a Miracast-enabled TV without
the need for cables. You can play games, browse the Inter-
net, play videos, or display a slide show wirelessly to your
TV without the need for cables.
Wireless Display Configuration
1. Note that no driver or application is required for wireless display
in Windows 10.
2. Press the + P (or Fn + F7) key combination.
3. An on-screen menu will pop up.
4. Click Connect to a wireless display (see sidebar if this does
not appear).
5. The system will then search for compatible display devices (this
may take up to 60 seconds so allow time for this to complete).
6. Double-click any detected display device in the list.
7. The display will then connect (for specific settings for your
display see the documentation supplied with your compatible
adapter/display for full details).
8. Press the + P (or Fn + F7) key combination, click Connect
to a wireless display and then click Disconnect to temporarily
disconnect from the wireless display.
1710.book Page 24 Monday, August 7, 2017 2:45 PM
To Next Page
Loading...