VOlTAGE BALANCING AND MONITORING IN THE DISCHARGE PROCESS
Voltage balancing and monitoring in the discharge process
The processor monitors voltage of each cell when the battery packs are during its "storage" and
"discharging" process. To achieve this feature, plug each battery to the charger individually. If
voltage of anycell is abnormal, B6+ will show error message and terminate the program forcibly.
So if there is battery damage or disconnection, you can see the error message and press INC to
know which cell is damaged.
BATTERYVOL ER R
CE LL LO W VOL
The processor detects voltage of one cell is too low.
I
INC~
'I'
1
The 4th cell was damaged. The value of voltage may be zero if
disconnection occurs.
'--------------'
4 14 4 16 4 09
2 18 0 00 0 00
~DEC INC~
Start '>3 second' . .
~-'="'-_'-'E"'n""e'--r _-,
"ThiS program charge the battery usmq the current you set up. In the
"auto" state, you should set up the upper limit of the charge current to
avoid damage by excessive feeding currerit. Some batteries of low
resistance and capacity can lead to higher current in the "auto" charging
mode. But inthe manual mode, it will charge with the current you set. You
can make it blink in the current field and press INC and DEC at the same
V
time to switch mode.
NIMH
2 OA 74 2V
CHG 022 45008 90
To Next Page
Loading...
Need help?
General
