FAST CHARGING OF LITHIUM BATTERY
Fast charging of lithium battery
[
~
Charging current will become lower when it progress to the end of
"""
•• • charging. Aspecific
CV
process will be reduced to end thecharging
,. process earlier. In fact. the charging current will goes to 1/5 when
the charging process comes to 1/10. Charging capacity will be a
_ +
11I1 -
+
little smaller than normal charging. but charging time will be
"'DEC INC~ "'DEC INC~
shortened accordingly.
Batt type Start, ,
Stop Enter>3seconds
You can set up the charging current and voltage ofthe battery pack.
r+: --','----__ ----, .
Press START/ENTER key to display voltage confirmation. Then
press START/ENTER key againto confirm and begin to charge.
LI3S 20A 1259V
FAS 022
4.3
00682
This screen shows the real-time status of "fast charging". Press
BATTTYPE/STOP keyonce to stop the charge process.
Storage control of lithium battery
This function is for charging/discharging batteries which are not used at once. This program is
designed for charging or discharging of batteries of specific original state. Theyare classified by
types:
3.75V
l.ilo,
3.85V
LiPo and
3.3V
LiFe. The program will begin to discharge if the original
state of the battery exceeds the voltage level of storage.
@
To Next Page
Loading...
