To Next PageTo Next PageWhat to do if my Powertronix Alcor UPS shows inverter overload?
If your Powertronix UPS indicates an inverter overload, it's likely due to a continuous overload on the UPS output. You should check the output load, restart the inverter, and also check for any short circuits in the output.
Why is my Powertronix UPS showing 'Mains Not Available'?
The 'Mains Not Available' message on your Powertronix UPS indicates that there is no mains input. Check the mains line voltage to ensure it is within the acceptable range.
What to do if Powertronix Alcor UPS shows battery test failure?
If your Powertronix UPS reports a battery test failure, it means the battery test was not successful. You should check the battery itself and also inspect the battery fuses.
General| Capacity | 600VA |
|---|---|
| Input Voltage | 230VAC |
| Output Voltage | 230VAC |
| Frequency | 50/60Hz |
| Battery Type | Sealed Lead Acid (SLA) |
| Communication Interface | USB |
