Need help?Do you have a question about the PowerWalker VFD 600 APFC and is the answer not in the manual?
General| Power Rating | 600 VA |
|---|---|
| Output Power | 360 W |
| Nominal Input Voltage | 230 VAC |
| Output Voltage Regulation | ±10% |
| Topology | Line-Interactive |
| AVR | Yes |
| Waveform Type | Simulated Sine Wave |
| Battery Voltage | 12 V |
| Battery Capacity | 7 Ah |
| Communication Interface | USB |
| Operating Temperature | 0-40°C |
| Form factor | Tower |
| Output Voltage | 230 VAC |
| Output Frequency | 50/60 Hz |
| Input Frequency | 50/60 Hz |
| Transfer Time | Typical 2-6 ms |
| Battery Type | Lead-Acid |
| Typical backup time at half load | 10 minutes |
| Typical backup time at full load | 3 minutes |
| Humidity | 0-90% non-condensing |
| Dimensions (W x D x H) | 145 x 330 x 195 mm |
Covers risks of electric shock, fire, and proper battery handling, emphasizing qualified personnel for servicing.
Details the top panel components including power switch, indicator LEDs, and various types of receptacles.
Describes the side panel features such as AC input, circuit breaker, and modem/phone line surge protection.
Inspect the UPS for shipping damage and install it in a suitable, protected environment.
Charge the UPS battery fully before use, typically for 8-10 hours with no load connected.
Connect computer-related devices to the battery-supplied receptacles on the UPS.
Plug peripheral equipment into surge outlets and connect modem/phone lines to designated ports.
Details circuit breaker reset, power on/off procedures, and the DC start function.
Guides on replacing batteries, stressing qualified personnel and proper disposal.
To Next Page
