Powrmatic VPx Series User Manual

page no. 11 of 40
VPx Range Users, Installation & Servicing Instructions Doc Ref M205 issue 1.2 Nov 2018.
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
A A
B B
C C
D D
E E
F F
"Title Here"
SCALE: 1:15
VPX - Flue Arrangements
SHEET 1 OF 1
"Description Here"
ISSDATEDCR
"Material Gauge & Spec Here"
MODIFICATIONSI/ADRN
UNSPEC. TOLS.
Hole centers ±0.1mm
General ±0.1mm
-
MM
Finished sizes ±0.1mm
DO NOT SCALE
TA19 9PS.
POWRMATIC LTD
Powrmatic Ltd. Hortbridge, Ilminster. Somerset.
This drawing is copyright and the property of POWRMATIC
LIMITED. It must not be used without their knowledge, nor
communicated to any other person or company.
01
NEW DRA
WING
-
10/09/2018chrisbromfield
-
TITLE:
DESCRIPTION:
Tel: 01460 53535 Fax: 01460 52341
Web: www.powrmatic.co.uk E mail: r&d@powrmatic .co.uk
DRAWING NUMBER:SALVAGNINI:
MATERIAL GAUGE & SPEC:
MATERIAL REQUIRED:
PROJECTION:
UNITS:
1
2
m
m
a
x
i
m
u
m
6
m
m
a
x
i
m
u
m
Terminal
Flashing
Single to twin adaptor
Lengths
Adjustable lengths
Condensate drain lengths
Flue socket
Combustion air socket
Flashing
Lengths
Terminal
Adjustable length
Condensate drain length
Flue socket
Combustion air entry
(fitted with inlet grille)
Combustion air entry
(fitted with inlet grille)
1.3.4.2 Meters
An existing meter should be checked, preferably by the
gas undertaking, to ensure that the meter is adequate
to deal with the total rate of gas supply required by all
connected equipment.
1.3.4.3. Installation Pipes
Installation pipes should be fitted in accordance with IGE/
UP/2. Pipe work from the meter to the air heater must be
of adequate size.
Do not use pipes of a smaller size than the inlet gas
connection of the heater.
The complete installation must be tested for soundness
as described in the above Code.
1.3.5 Flue System
Only flue systems supplied through Powrmatic Ltd may
be used with VPx units. Several configurations of flue and
combustion air ducts are available.
The flue must terminate in a freely exposed position and
be sited to prevent the products of combustion entering
any opening in a building in such concentration as to be
prejudicial to health or a nuisance.
Type B22 Installation.
Vertical Outlet
1.3 General Requirements
Type B22
Installation.
Horizontal Outlet
Type C12 or C32 Installation.
Vertical Outlet
Type C12 or C32 Installation.
Horizontal Outlet
1
1
2
2
3
3
4
4
5
5
6
6
7
7
8
8
A A
B B
C C
D D
E E
F F
"Title Here"
SCALE: 1:15
VPX - Flue Arrangements
SHEET 1 OF 1
"Description Here"
ISSDATEDCR
"Material Gauge & Spec Here"
MODIFICATIONSI/ADRN
UNSPEC. TOLS.
Hole centers ±0.1mm
General ±0.1mm
-
MM
Finished sizes ±0.1mm
DO NOT SCALE
TA19 9PS.
POWRMATIC LTD
Powrmatic Ltd. Hortbridge, Ilminster. Somerset.
This drawing is copyright and the property of POWRMATIC
LIMITED. It must not be used without their knowledge, nor
communicated to any other person or company.
01
NEW DRA
WING
-
10/09/2018chrisbromfield
-
TITLE:
DESCRIPTION:
Tel: 01460 53535 Fax: 01460 52341
Web: www.powrmatic.co.uk E mail: r&d@powrmatic .co.uk
DRAWING NUMBER:SALVAGNINI:
MATERIAL GAUGE & SPEC:
MATERIAL REQUIRED:
PROJECTION:
UNITS:
1
2
m
m
a
x
i
m
u
m
6
m
m
a
x
i
m
u
m
Terminal
Flashing
Single to twin adaptor
Lengths
Adjustable lengths
Condensate drain lengths
Flue socket
Combustion air socket
Flashing
Lengths
Terminal
Adjustable length
Condensate drain length
Flue socket
Combustion air entry
(fitted with inlet grille)
Combustion air entry
(fitted with inlet grille)

Powrmatic VPx Series Specifications

General

Brand	Powrmatic
Model	VPx Series
Category	Heater
Language	English