PPC ID-2000 Series - Technical Specifications

36
2. Other problems
Trouble Solution
Found frequently ribbons cut
in the front edge of card when
printing
- In printer driver or The Designer settings, increase Print
Start Position.
Found frequently ribbons cut
in the rear edge of card when
printing
- In printer driver or The Designer settings, increase Print
End Position.
Printer not found in The Designer or
application software
- Check that printer driver is correctly installed.
- Check that communication cable is properly connected
- Reboot your PC.
Other than power LED,
4 Front LEDs continuously flash
in sequence
- Check out http://www.ppc.au/support for firmware download.
- Download the latest version of firmware for the printer.
- Perform install using firmware install program.
Firmware installation not
performed
- With pressing "EJECT", "RESET" switch at the same
time, place power switch in the ON position.
- Check that front 4 LEDs flash in sequence, install
firmware using firmware install program.
Card Printer ID-2000 Series