22
Setting Meter Parameters
Setting Time & Date
When you rst time installing the battery into the
meter or when replacing a battery, the meter will
connect with GSM system. If it succeeds to connect,
the time and date will be updated automatically. If
the connection is failed, the “Err“ message will show
up. Please refer to chapter “Display Messages and
Problem-Solving Guide “
1. Press Mem button, the meter will enter to the
setting of “year”. Press Set button to select
the desired year.
2. Press Mem button to conrm and shift to the
next setting.
3. Repeat above steps to set the month, day, hour
and minute by Set and Mem buttons.
4. After minute is set, the meter will display “OK”
before turning off.
NOTE: WHILE SETTING THE TIME AND DATE, YOU CAN
EXIT THE SETTING MODE ANYTIME BY PRESSING Mem
BUTTON FOR 3 SECONDS.
23
Setting Temperature Unit/ 12h,24h period/ Alarm
Celsius and Fahrenheit can be set according to
your preference.
1. Press Set and Mem buttons at same time for 2
seconds to turn on the meter.
2. Then Press Set button to choose between “C” (for
Celsius) and “F” (for Fahrenheit).
3. When Temperature Unit preference is set,
press Mem button to enter the 12h/24h period
setting.
4. Press Set button to choose your preference of
12h/24h period.
5. The PRECICHEK has 5 alarms to keep your
blood glucose monitoring on time. Press Set
button to turn on or turn off the alarm.
• When “ON“ is choosen, press Mem button
to congure the alarm hour. Press Set but-
ton to change hour. When alarm hour is set,
Press Mem button to configure the alarm
minutes. Press Set button to change minutes
To Next Page
Loading...