Watch Hands (hour, minute and second hand) Alignment
The watch hands need to be aligned when the watch hands are shifted
1. Pull out the crown when the second hand is at 12:00:00 to stop it from running
2. Rotate the crown to set Hour and Minute hands at 12:00:00
3. Don’t push in the crown. Hold S1 for around 10 seconds and then release the button
4. Push in the crown
5. The hands start spinning. Wait until the watch matches with the internal time and resume normal
running.
TROUBLESHOOTING
Second Hand Shifting
Your watch is a very delicate and precise instrument. Although uncommon, sometimes hard knocks or
vibrations can cause the hands to move irregularly, and therefore display the incorrect time, although
the internal clock is keeping accurate time. You may notice this when setting the LCD to “Second” and
nd that it is not synchronized with the analogue second hand. This shows the reference point of the
analogue second hand has changed and the watch needs to be reset. Please go to “Reset the Watch”
for details.
Watch Not Receiving Time Signal
Reason for not being able to receive the time signal include:
• Being outside of the radio signal area
• Being in a built up area
• Metal objects blocking the radio signal
• Interference by computer monitor or TV
Ensure the watch is left by a window, as this gives the best reception. You may have to try dierent
windows in the house to see which is best. You can test this by using reception status test described
earlier. Please note that reception is always better at night.
11
To Next Page
Loading...
Need help?
General
