Manual Signal Reception
• Holding S1 for more than 3 seconds until the LCD display shows the Antenna icon. There is
one digit on the right hand side of the display showing the signal to receive. Where US=WWVB,
J4=JJY40, J6=JJY60, UK=MSF and DE=DCF. At the same time, the second hand pauses at 12
o’clock during signal reception (for all Time Zones).
• Put the watch (with face-up or face-down, never put the watch on its side) near a window to get
signal.
• After reception, the watch will show the time when the fast running of the minute hand has stopped.
During signal reception, the LCD display shows the signal-strength. Search for a location where the
signal is the strongest for a good signal reception.
Reception Status Check
You can check if the watch is able to pick up signal.
Press S1 once to check (while the watch runs normally).
• If reception OK the LCD window shows OK
• If reception FAILS the LCD window shows NO
Explanation: For Japan signal, the watch shows J6 when signal reception is successful.
Where, J6 means JJY60Khz signal.
LCD Display Selection:
You can set the watch to show either one of the following digital readings on the LCD display.
• Day
• Date and Month
• Month and Date
• Hour : Minute
• Second
• Battery level with charging indication if battery level is not full
Press S2 (bottom right button) one after another to select to set your preferable display. The LCD
display responds on your second press of the S2 button.
7
To Next Page
Loading...
Need help?
General
