Reset the Watch
1. Pull out the crown when the second hand has paused at 12:00:00 to stop it from running
2. Rotate the crown so that the Hour and Minute hands are aligned at 12:00:00.
3. Don’t push in the crown. Hold S2 for around 10 seconds and then release the button
4. Push in the crown
5. The hands start normal running
6. The LCD display shows “LON”. This is the pre-set Time Zone of the watch – LONDON, UK.
7. Set your Time Zone by S1. For Germany, please set it to BER. For America, please set it to LAX,
DEN, CHI or NYC.
8. Press-release S2 to conrm
9. The watch will now initiate a signal reception automatically. Put the watch near a window and let
it rest on its side or in a face-down position (make sure the metal band doesn’t touch the case-
back of the watch).
10. The watch will run to the right time if the reception is successful otherwise it will run at 12 o’clock
if the reception has failed.
11. Place your watch near a window to get a signal if the initial reception has failed. The watch will start
to update the signal at the beginning of the next hour. It will continue updating signal for the coming
24 hours. The hands move on to the correct time after receiving a valid time signal.
PLEASE NOTE:
Make sure you check that the battery level is at least half-full before doing the RESET. If the battery level
is not half-full, charge up the watch until it reaches this level.
Express Second Hand Alignment
You can align the second hands by the below express method if it experiences minor shifting. However
it is a little complicated and requires some good judgment. If you are not able to set the shifted second
hand using the below method then you need to follow the “Reset the Watch” to align the watch hands.
13
To Next Page
Loading...
Need help?
General
