Precor C966i Product Owners Manual

Product Owner’s Manual: Club Features 20
Treadmill: Changing Remote
Control Access
Important: To affect this setting, the treadmill must be connected to a
computer and you will need to be familiar with CSAFE commands.
When you enable this program, you can set a user’s speed and incline
through a computer software program which interfaces with the
CSAFE port on the treadmill.
The default factory setting is set to DISABLED. To change this setting,
perform the following steps:
20. At the REMOTE CONTROL prompt, press OK. Use an arrow key
to alternate between the two selections.
21. When you are ready, press OK to accept the displayed setting and
move to the next program. Or, press PAUSE/RESET to return to
the Precor banner.
EFX: Changing the Auto-Level Setting
You can set a specific ramp incline so that the EFX automatically
returns to it at the end of a workout session. Whatever incline you set,
the EFX ramp returns to the setting if a user continues pedaling, once
the program session has ended, and presses PAUSE/RESET to
return to the Precor banner.
Note: This setting is only available on EFX units with adjustable
ramps.
Important: If you use this feature, connecting the optional power
adapter is recommended. Instruct users about the auto-leveling
feature and ask that they hold onto a stationary handrail with one
hand while the unit automatically moves to the set incline.
22. At the SET CROSSRAMP AUTO-LEVEL prompt, press OK.
23. XRAMP n appears, where n is the ramp incline setting. Use the up
or down arrow keys to select the desired ramp incline setting from
1 to 20.
24. When you are ready, press OK to accept the displayed setting and
move to the next program. Or, press PAUSE/RESET to return to
the Precor banner.
Setting Description
ENABLED Lets you set the speed and incline for individual users
and their selected program using CSAFE commands
through a computer connection.
DISABLED Disconnects remote access so you cannot use the
remote capabilities of a CSAFE connection. You
would also use this setting when the treadmill is not
connected to a computer.

Precor C966i Specifications

Power and Motor

motor power	4.0 hp continuous duty
power requirements 120v	120 v @ 50/60Hz 20 Amps
power requirements 240v	240v @ 50/60Hz 20 Amps

Performance

speed range	0.5 to 16 mph (1 to 26 kph)
incline range	-3% to 15% grade

Weight and Dimensions

length	86 inches (218 cm)
width with handrails	37 inches (93 cm)
width without handrails	34 inches (86 cm)
height	59 inches (150 cm)
weight	375 lbs (170 kg)
shipping weight	470 lbs (213 kg)
running surface	60 inches x 20 inches (153 cm x 51 cm)