EFX576i Elliptical Fitness Crosstrainer Assembly Guide 1
Thank you for choosing Precor. For proper installation, please read this guide
thoroughly and follow the assembly instructions. If you do not assemble the
EFX according to these guidelines, you could void the Precor Limited Warranty.
Obtaining Service
You should not attempt to service the EFX except for maintenance tasks as
described in the Product Owner’s Manual. If any items are missing, contact
your dealer. Should you need more information regarding customer support
numbers or a list of Precor authorized service centers, visit the Precor web site
at www.precor.com/corp/contact.
Unpacking the Equipment
The unit is shipped in one box. Ask for help from two or more people to unpack
and assemble the EFX.
Required Tools
• Wire tie cutter
• Phillips-head screwdriver
•Two ⁹⁄₁₆-inch combination wrenches (open-end and box)
• SAE Standard socket set
Cardio Theater PVS
Assembly Instructions
If the Cardio Theater Personal Viewing System (PVS) accompanies this Precor
unit, review the PVS assembly instructions found in the Cardio Theater box.
Alleviate additional assembly or disassembly steps by combining the two
assemblies as needed.
Installation Requirements
Follow these installation requirements when assembling the unit:
• Assemble the unit near the location where you plan to use it.
• Provide ample space around the unit.
Open space around the unit allows for easier access.
• Set up the unit on a solid, flat surface.
A smooth, flat surface under the unit helps keep it level. A level unit has
fewer malfunctions.
• Open the box and assemble the components in the sequence
presented in this guide.
• Insert all fasteners with your fingers.
Use your fingers to properly align and thread the fasteners. This helps
alleviate cross-threading. Do not fully wrench tighten fasteners until
instructed to do so.
Important: When wrench tightening, the head of the fastener should be
flush with the product. If it is not, cross-threading has occurred. Do not
attempt to rework the assembly as more damage to the equipment will
occur. Contact Customer Support. Refer to Obtaining Service.
• If you plan to move the unit, obtain help and use a hand truck.
Do not grasp any plastic parts while lifting or moving the unit. The plastic
parts are not capable of supporting the weight of the unit and they may
break.
To Next Page
Loading...
Need help?
Power and Motor
Performance
Weight and Dimensions
