Precor C966i Service Manual

C956i, C966i (Gen 06) Treadmill
Page 37
6. Remove the two screws retaining the circuit breaker and remove the circuit breaker.
7. Reference the label on the replacement circuit breaker and set the circuit breaker in its
mounting position with the “LINE” side of the breaker facing the input module and the
“LOAD” side of the circuit breaker facing the AC line filter. Fasten the circuit breaker with the
hardware removed in step 6.
8. On 120 Vac treadmills connect the blue wire from the input module to the “LINE” terminal on
the circuit breaker and the blue wire from the AC line filter to the “LOAD” terminal on the
circuit breaker.
9. On 240 Vac treadmills connect the blue wire from the input module to the upper “LINE”
terminal on the circuit breaker and the blue wire from the AC line filter to the upper “LOAD”
terminal on the circuit breaker. Connect the brown wire from the input module to the lower
“LINE” terminal on the circuit breaker and the brown wire from the AC line filter to the lower
“LOAD” terminal on the circuit breaker.
10. Set the input panel in its mounting position and fasten it with the hardware removed in step
3.
11. Thoroughly check the treadmill per Section 3.

Precor C966i Specifications

Power and Motor

motor power	4.0 hp continuous duty
power requirements 120v	120 v @ 50/60Hz 20 Amps
power requirements 240v	240v @ 50/60Hz 20 Amps

Performance

speed range	0.5 to 16 mph (1 to 26 kph)
incline range	-3% to 15% grade

Weight and Dimensions

length	86 inches (218 cm)
width with handrails	37 inches (93 cm)
width without handrails	34 inches (86 cm)
height	59 inches (150 cm)
weight	375 lbs (170 kg)
shipping weight	470 lbs (213 kg)
running surface	60 inches x 20 inches (153 cm x 51 cm)