C956i, C966i (Gen 06) Treadmill
Page 7
Procedure 2.2 - Displaying Information
The information display will access the following data;
• Odometer
• Hour Meter
• U-Boot Software
• U-Base Software
• Lower Software
• Serial Number
• Usage log
• Error Log
Procedure
1. Plug the power cord into the wall outlet, then turn on the treadmill with the circuit breaker.
2. With the PRECOR banner scrolling, press the keys RESET,6,5, sequentially.
3. DIAGS-INFORMATION DISPLAY will scroll across the display.
4. Use the , keys to move to the desired display shown in the list above.
5. ODOMETER display. Press the OK key.
6. The odometer will be displayed as 1234567 MILES or 1234567 KM depending on club
parameter settings (See Procedure 2.3). The odometer is also used to provide the “distance
stamp” for the error code log
Note: The odometer data is stored in non-volatile memory on the upper PCA. If the upper PCA
is replaced the odometer data will be lost.
7. Press the BACK key to exit the odometer display.
8. HOUR METER display. Press the OK key.
9. The operating time of the unit will be displayed as 12345 HOURS. The operating time is
defined as total amount of time that the unit has operated in program modes with the drive
motor running. The hour meter is also used to provide the “time stamp” for the error code
log.
10. Press the BACK key to exit the hour meter display.
11. U-BOOT SW display. This display the installed version of upper boot software. The boot
software is used to upload new software into the upper display PCA.
12. Press the OK key. The software part number will be displayed as XXXXX-XXX.