Precor C966i Service Manual

C956i, C966i (Gen 06) Treadmill
Page 1-6 Page 6
4. Press the OK key, the upper most group of LED’s will illuminate on the display. Check the
display to ensure that all LED segments are illuminated.
5. Press the OK key four more times to display the remaining LED groups. Check each display
group to ensure that all LED segments are illuminated.
6. Press the BACK key then the  key, KEYBOARD TEST will scroll across the display.
7. Press the OK key, a representation of all of the keys on the console will be displayed.
Pressing a key on the console will cause the representation of that key to go off. Press all of
the keys on the console to ensure that all of the keys are functioning.
8. Press and hold the BACK key then the  key, HEART RATE will be displayed.
9. Grasp both of the heart rate grips on the handlebar, after a couple of seconds the heart rate
will be displayed in the heart rate and smart rate displays.
10. Use chest strap transmitter or a test transmitter to test the wireless heart rate function, after
a couple of seconds the heart rate will be displayed in the heart rate and smart rate displays.
11. Press the BACK key then the  key, MACHINE TEST will scroll across the display.
12. You may now proceed to either the belt speed test or the incline test. Press the  key once
to access the belt speed test or twice to access the incline test.
13. BELT SPEED test. Press the OK key, the console will display the power bits (PWRB), Press
the SPEED  key to start the treadmill running belt, the display will indicate the power bits,
the elapsed time and the actual speed (in either miles per hour or kilometers per hour
depending on the club parameters setting, see Procedure 2.3).
14. Press the  key, the console will display the motor current (AMPS), the elapsed time and
the actual speed.
15. Press the BACK key to exit the belt speed test.
16. INCLINE test. The console will display the analog to digital (A/D) incline position number
and the incline position in percent of incline. Press the inline , keys to operate the incline
through out its range.
17. Press the BACK key to exit the incline test.
18. Press the RESET key to exit the hardware validation test.

Precor C966i Specifications

Power and Motor

motor power	4.0 hp continuous duty
power requirements 120v	120 v @ 50/60Hz 20 Amps
power requirements 240v	240v @ 50/60Hz 20 Amps

Performance

speed range	0.5 to 16 mph (1 to 26 kph)
incline range	-3% to 15% grade

Weight and Dimensions

length	86 inches (218 cm)
width with handrails	37 inches (93 cm)
width without handrails	34 inches (86 cm)
height	59 inches (150 cm)
weight	375 lbs (170 kg)
shipping weight	470 lbs (213 kg)
running surface	60 inches x 20 inches (153 cm x 51 cm)