Precor Experience TRM681 User Manual

ID Description
Power Entry Assembly Bracket
Power Cord Inlet Assembly
ON/OFF SW Circuit Breaker
Removal Instructions
1. Switch the power OFF and unplug
1
the power cord.
TIP: For easier access, raise the incline to maximum before removing power.
Access the service Hardware Validation (51765761) and use the
CROSSRAMP/INCLINE Test to raise the incline and then remove power.
2. Remove the hood cover, see "Hood Cover Replacement" on page 82.
3. Remove the four #3 Phillips fasteners and remove the Power Entry Assembly bracket
. Hold the bracket while removing to prevent wire cable damage. Retain part(s)
and/or fastener(s) for installation.
1
Disconnect a device power cord plug or cable connector from the power receptacle or out-
let.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 104
6 Replacement Procedures
ON/OFF Circuit Breaker Switch Replacement

Precor Experience TRM681 Specifications

General

Brand	Precor
Model	Experience TRM681
Category	Treadmill
Language	English