12. If the MC fasteners were loosened or removed, reinstall fasteners (4x) and fully
tighten, see "Motor Controller (MC) Replacement" on page 107.
Remove blocking and lower treadmill
Note: If you used the side access method, then refer to the "Side lift motor
jackscrew access" procedure to upright the treadmill, see "Side access" on
page 76.
13. .Connect the power cord and switch the power ON. Be aware that switching the
power ON will cause the incline platform to move and return to the level "0" position.
WARNING: Keep hands and appendages clear of the lift platform assembly
before switching power ON. Switching power ON will cause the incline platform to
move to the level "0" Home position.
14. Access the service menu (51765761) and select the INCLINE TEST, see "How to
Access the Standard Service Menus" on page 29. Increase the incline level enough
to lift the treadmill frame off the supports.
15. Remove the supports and clear any other items that might either block the treadmill
from lowering or may be damaged as it lowers.
16. Lower the incline to level "0".
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 165
6 Replacement Procedures
Lift Motor Replacement
To Next Page
Loading...
