page 13
COMMERCIAL PRODUCTS DIVISION
cutter (or scissors) to remove the plastic grommet from the cable.
7. Insert the plastic grommet. Diagram 5. Place the grommet into the hole on
the front base assembly. Press down so that it snaps into place.
8. Prepare for the attachment of the upright support to the base
assembly. Diagrams 6 and 7. Remove the four phillips-head screws (D),
two bolts (G), and two washers (H) from the Hardware kit. Place one washer
(H) on each of the two bolts (G). Keep the fasteners together.
CAUTION: Do not stretch, crimp, or damage the cable. Excess cable may
be gently pushed into the base assembly. Cables damaged by improper
installation will not be covered by the Precor limited warranty.
9. Route the display console cable through the upright support. Diagram 6, #1
Remove any tape or wire ties on the cable. Have an assistant hold the upright
support securely while you grasp the display console in one hand and route the
cable through the upright support with the other.
Diagram 6
Route the cable and
attach the display
console to the
upright support.
Display console
Upright support
Cable
2
1
To Next Page
Loading...
