page 14
COMMERCIAL PRODUCTS DIVISION
10. Attach the display console. Diagram 6, #2. Use the four phillips-head
screws (D) to attach the display console to the upright support. Have your assis-
tant hold the upright support securely while you align the mounting holes and
tighten the screws.
11. Position the upright support over the base. Diagram 7. Have your assistant
move the upright support close to the front of the base assembly while you
thread the cable through the grommet hole and out the front of the base tube
(see inset #1). Make sure that the display console (on the upright support)
faces the rear of the unit (see inset #2).
CAUTION: As you assemble the unit, do not fully tighten the fasteners until
instructed to do so. Finger tighten the fasteners or use the hex
key so that the unit is stable, but the fasteners still allow room for
adjustments.
Diagram 7
Route the cable
through the grommet
and attach the upright
support.
Cable connector
Have your assistant
hold the upright
support while you
secure it to the base.
2
1
Two bolts (G)
with washers (H)
Cable receptacle
Upright
support
Base
assembly
Base tube
Diagram 8
Connect the
cables.
Cable connector
Cable receptacle
Place excess cable
into the base tube.
Height adjustor
threads
Base tube
To Next Page
Loading...
