page 15
COMMERCIAL PRODUCTS DIVISION
12. Secure the upright support to the base assembly. Diagram 7. Align
the mounting holes and thread the two bolts (G) with washers (H) through
opposite sides of the upright support and into the base assembly. Finger
tighten each bolt. Do not fully tighten the fasteners until the entire unit has
been assembled.
13. Connect the cable. Diagram 8, inset. Insert the cable into its receptacle.
Just like a telephone connection, a definite "click" is heard when a good
Diagram 9
Place the base
on supportive
blocks.
Adjustable rear pad
Supportive
wedge
Base assembly
connection is made. If you do not hear a "click," try reinserting the cable
connection again.
14. Push excess cable inside base tube. Diagram 8. Carefully, push any
excess cable behind the height adjustor threads that protrude from inside
the base tube.
15. Rotate the rear pads. Diagram 9, inset. Ask your assistant to stabilize the
unit while you rotate the rear adjustable pad to the highest position. This
To Next Page
Loading...
