Precor move beyond S3.15 Assembly Instructions

S3.15/S3.19 Leg Press Option Assembly Instructions
page 5
2
Preparations
Preparations
You must review and follow the instructions in this
guide. If you do not assemble and use the Leg Press
Option according to the following guidelines, you could
void the Precor Limited Warranty.
Required Tools
Tools that you need to obtain before assembling the
unit include:
❏ ⁹⁄₁₆-inch socket
❏ ³⁄₄-inch socket
❏ ⁹⁄₁₆-inch box-end wrench
❏ ³⁄₄-inch box-end wrench
❏ Crescent wrench
❏ Wire tie cutter (cuts plastic tie wraps)
❏ Utility knife
Installation Requirements
Follow these installation requirements when
assembling the unit:
• Fill out and mail the warranty registration card.
• Set up the Leg Press Option on a solid, flat
surface. A smooth, flat surface under the unit
helps keep it level.
• Provide ample space around the machine.
Open space around the machine allows for easier
access.
• Insert all fasteners in the same direction. For
aesthetic purposes, insert all the fasteners in the
same direction unless specified (in text or
illustrations) to do otherwise.
• Leave room for adjustments. Tighten fasteners
(such as screws, nuts, and bolts), so the unit is
stable, but leaves room for adjustments. Do not
fully tighten fasteners until instructed (in the steps)
to do so.
Assembly Tips
• Fasteners may become loose and fall off during
shipment. Inspect the plastic wrap and packaging
for loose parts. To alleviate confusion during
assembly, reattach the loose fasteners and pulleys
found in the packaging.
• A black 6-inch scale with white numbers is
provided at the bottom of every assembly
instruction page. Use this scale to identify the
correct fastener size. The head of a fastener is not
used in measuring the length.
• Most fasteners are ³⁄₈-inch unless otherwise noted.
To find out the length of a particular fastener,
measure its shank (the long, narrow part beneath
the head). Refer to the following diagram:
• Zinc fasteners are used with the titanium parts.
Black fasteners are used when assembling the
stone gray painted surfaces.
• Most fasteners are fitted to the frame or pulley, you
will need to disassemble the fasteners before
proceeding with each step. Some pieces have
extra holes that you will not use. Use only those
holes indicated in the instructions and illustrations.
• Read all caution notes on each page before
completing that step.
• While you may be able to assemble the Leg Press
Option by reading the illustrations only, refer to the
text for important safety cautions and notes. The
S3.15 is shown throughtout the assembly
instructions. If you purchased the S31.9, the Leg
Press Option assembly is identical.
Fastener head
Fastener threads
Shank
To determine the
length of a fastener,
measure its shank.

Precor move beyond S3.15 Specifications

Weight and Dimensions

length	72 inches (182 cm)
height	83 inches (211 cm)
width	51 inches (130 cm)
shipping weight	221 lb (100 kg)