The restart switch and the red STOP button are located just below the console, as shown in the following figure.
When the switch is tripped, the button pops up. The treadmill does not operate until the button pressed to its
normal position.
Instruct users to use the safety clip while exercising on the treadmill, and demonstrate how they should attach it
to their clothing near the waistline.
If the restart switch trips during exercise, perform the following steps:
1. Reattach the safety clip if necessary.
2. Press the restart switch down until it clicks, returning it to its normal position.
Note If the restart switch trips, all information about the current workout is deleted.
3. Start the workout from the beginning, reducing the time as needed to account for the amount of exercise
that has been completed.
Tip The small, flexible tab underneath the restart switch is designed for storage of the safety clip. When the
treadmill is not in use, attach the safety clip to the tab as shown in the following figure.