Precor SPINNER CLIMB User Manual

Note:Do not install a zip tie to hold the moisture barrier cover over the LPCA board.
2. Reconnect the battery cable Red wire to the Positive (+) battery terminal and then the
Black wire to the Negative (-) battery terminal, see "Battery Replacement" on
page43. Reconnect the Negative terminal cable last:
3. On LPCA board PN 304638-101
a. Do the AutoCal R1 procedure and verify the WATTS measurement at minimum
and maximum resistance, see "" on page19.
4. On LPCA board PNs 304638-102 and later
a. Do the AutoCal R1 procedure and verify the WATTS measurement at minimum
and maximum resistance, see "" on page20.
5. Reinstall the front and rear belt guard covers, see "Belt Guard Cover Replacement"
on page47.
6. (missing or bad snippet)
.See Also
"Replacement Procedures" on page41
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 120
5 Replacement Procedures
LPCA board Replacement

Precor SPINNER CLIMB Specifications

General

Brand	Precor
Model	SPINNER CLIMB
Category	Exercise Bike
Language	English