Assembling the Treadmill
5
Assembling the Treadmill
CAUTION: The location of the On/Off switch is beneath the cutout on the base frame.
Make sure the power switch is in the Off position. Make sure the power cord is
disconnected from its power source.
Figure 1: On/Off switch in Off position
Proper alignment and adjustment of the equipment is critical. When you install
fasteners, leave room for adjustments. Do not fully tighten the fasteners until you are
instructed to do so.
The following figure shows the names used in this manual for the major
components of the equipment.
Figure 2: Major components of treadmill
To Next Page
Loading...
Need help?
General