24 Assembling and Maintaining TRM 800-Series Treadmills
3. Feed the data cable from the treadmill drive unit through
the cable channel in the upright support on your left, from
bottom to top.
4. Place the upright support on your left onto its base frame
side bracket, making sure that the rounded edge of the
upright support faces you.
5. Secure the upright support to the side bracket using three
³₈-inch × 1-inch buttonhead screws and three ³₈-inch
narrow flat washers. Partially tighten the fasteners using a
⁷₃₂-inch hex wrench.
Figure 5: Upright support attachment
6. Pull the data cable gently upward through the upright
support to remove any extra cable from the base of the
treadmill. Drape the upper end of the data cable over the
inside edge of the upright support, using tape to hold it in
place if necessary.
7. Place the remaining upright support over the base frame
side bracket on your right so that the rounded edge of the
upright support faces you. Secure the upright support to
the side bracket using four ³₈-inch × 1-inch buttonhead
screws, then partially tighten the fasteners using a
⁷₃₂-inch hex wrench.
To Next Page
Loading...
