Assembling the Treadmill 25
If the treadmill is equipped with a P80 console, you will need
to replace the power harness in the treadmill base with the
replacement power harness packed with the console. The
replacement harness includes an additional connection to
supply power to the consoleās DC power supply.
To attach the DC power supply (treadmills with P80
consoles only):
1. Disconnect the existing power harness from the drive
unit, the power filter, and the ground terminal. Remove
the power harness from the treadmill.
Figure 6: Removal of existing power harness
To Next Page
Loading...
