Section 4 - OPERATION
17
© Copyright 2006 PREO SRL
All rights reserved
EAW530E2MV
Edition
03/2006
Section 4
OPERATION
4.1 FILLING THE MELTING TANK
Before filling the melting tank, we recommend making sure that the hot-melt
adhesive to be used is compatible with the applicator specifications.
Always refer to the adhesive specifications indicated in the manufacturers’ technical
outlines.
PREO may not be held responsible for damage caused by incorrect use of the
recommended parameters.
Fill the tank as described and illustrated in figure 16.
Figure 16
• Open the tank cover.
• Fill the tank with the product, not exceeding the capacity of the tank itself.
• Close the cover.
Use of the applicator for processes other than that for which it was designed
and the use of adhesives or products that do not comply with the specifications
will irreparably damage the equipment and pose a hazard to the operator and
surrounding environment.
4.2 STARTING UP THE SYSTEM
Before starting the applicator, make sure that:
• The system is completely installed, including the electrical and
pneumatic connections (if necessary).
• The hoses and guns are correctly connected.
To Next Page
Loading...
Need help?
General