128-9351
12 of 16
Page 12
PROGRAMMING BANK 3 (REMOTE START ):
You can enter Bank 3 from Bank 2 by turning the ignition key off then on after you've
made the changes you wanted in Bank 2, (Siren two Long Chirp). You can also go right
to bank 3 by:
1) Turn the ignition key to the On position.
2) Press and release the valet/programming switch 3 times (Siren Chirps).
3) Turn the ignition key off then on. (Siren Short Then long Chirp)
4) Turn the ignition key off then on. (Siren two Long Chirp)
5) Press the push button switch once to advance to feature 1, twice to advance to fea-
ture 2, etc,,,then use the lock button of the transmitter to select the feature setting.
Example to set engine input check to DBI Tach:
1) Turn the ignition key to the On position.
2) Press and release the valet/programming switch 3 times (Siren Chirps).
3) Turn the ignition key off then on. (Siren Short Then long Chirp)
4) Turn the ignition key off then on. (Siren two Long Chirp)
5) Press the pushbutton switch ve times to advance to features 5, Input Check, then
use the lock button of the transmitter to select three chirps, "DBI Tach"
6) To exit the programming mode, turn the ignition key off. The program mode is auto-
matically exited when there is no activity on the pushbutton switch or the transmitter
lock button.
TACH RATE PROGRAMMING:
1. Turn the ignition key to the On position.
2. Press and release the valet/program push button switch 3 times.
3. Immediately turn the ignition key Off.
4. Press and hold the valet/program push button switch, then start the vehicle using
the key.
5. When the unit senses the tach signal, the parking lights will begin to ash.
6. Allow at least 5 ashes then release the valet/program pushbutton switch. The parking
lights will turn on for three seconds to indicate that the learned tach signal is stored
and the unit is out of the tach learn mode.
NOTE: If the unit fails to learn tach rate due to an improper tachometer connection or
a poor tach source, the parking lights will not ash. To correct this situation,
locate and connect the Green/Orange wire to the proper tach signal, and then
repeat the tach learn routine.
To Next Page
Loading...
