Primer DS-17 - User Manual

Questions and Answers

J
James MontgomeryAug 9, 2025
Why won't my Primer Dryer start?
- B
  Brittany LewisAug 9, 2025
  Your Primer Dryer might not be starting due to several reasons. Ensure the timer is correctly set and not at 0. Check that the door and filter cover are fully closed. If the emergency stop button is engaged, turn it a quarter turn to disengage it. Also, verify that the main power switch is ON and that the fuses are in good condition. If the issue persists, the door or cover micro might be faulty and need replacement. Finally, ensure the mains voltage is correct.
A
Alicia MarshallAug 19, 2025
What to do if Primer Dryer does not dry enough?
- A
  Andrew MartinAug 19, 2025
  If your Primer Dryer isn't drying sufficiently, try these steps: First, increase the cycle time. Then, clean the fluff filter to ensure sufficient airflow. Also, check that the outlet conduit is clean and not blocked, and clean the fan-extractor blades. Ensure the outlet conduit isn't too long and that the room has sufficient fresh air inlets.
K
Karen McbrideAug 29, 2025
Why is my Primer Dryer not heating up?
- N
  Nicole GarciaAug 29, 2025
  If your Primer Dryer isn't heating up, it could be due to several reasons. If the timer is in Cool-Down, increase the selected time. Check the thermostat and control electronic plate to ensure the heating is receiving an ON signal. Also, check the safety thermostat. If there's a gas alarm, reset it. Finally, ensure there is sufficient steam pressure by turning on the steam boiler.