Need help?Do you have a question about the Primera AP360 and is the answer not in the manual?
General| Imprint size | - mm |
|---|---|
| Product color | Black |
Steps to apply a single label using the foot switch.
Configure AP362 for two labels with adjustable distance.
Formula and example for calculating distance between two labels.
Use AP362 control panel to count and reset labels.
Switch between metric (cm) and imperial (inches) units.
Set container roller motor to Run After Apply or Stop After Apply.
Resolve issues with labels applied crookedly, considering container taper and guide positioning.
Apply labels straight on tapered containers like wine bottles.
Address motor stalling with wider label stock (6 inches or more).
Prevent slow operation by ensuring foot switch is not depressed during boot-up.
Prevent small containers from being pushed off rollers during application.
Minimize wrinkles/bubbles from container shape or surface irregularities.
Clean sensor flag with Q-tip and alcohol for adhesive buildup.
Leave Liner Idler Roller unclamped when not in use to prevent indentations.
Lubricate liner drive and idler roller bearings as recommended.
Periodically clean label gap sensor flag for proper operation.
To Next Page
