Normally, the Cube is positioned underneath the focus position of the beam path for
power measurement (divergent laser radiation). If this is not possible, the Cube can be
positioned above the focus. Please note that the laser radiation is convergent and the
permitted power density on the absorber (about 25mm under the protective glass) is
not exceeded.
Focusing optics
Focusing plane
Focal width fapprox. Focal width f
Max. 25mm with standard absorber
Max. 30mm with advanced absorber
See chapter „Technical Data“
Cube
Fig. 7.1: Alignment to the laser beam
To Next Page
Loading...
