21
English
Installation
Installation Procedure
Installing onto Display Module / DC Power Supply
Adapter for Box Module
Be aware of the following when building this product into an end-use product:
• The rear face of this product is not approved as an enclosure. When building this
product into an end-use product, be sure to use an enclosure that satisfies
standards as the end-use product’s overall enclosure.
• Install this product in an enclosure with mechanical rigidity.
• This product is not designed for outdoor use. UL certification obtained is for
indoor use only.
DANGER
HAZARD OF ELECTRIC SHOCK, EXPLOSION OR ARC FLASH
• Remove all power from the device before removing any covers or elements of
the system, and prior to installing or removing any accessories, hardware, or
cables.
• Unplug the power cable from the Display Module or DC Power Supply Adapter
for Box Module, and the power supply.
• Always use a properly rated voltage sensing device to confirm power is off.
• Replace and secure all covers or elements of the system before applying
power to the Display Module or DC Power Supply Adapter for Box Module.
Failure to follow these instructions will result in death or serious injury.
NOTICE
EQUIPMENT DAMAGE
• When mounting this product vertically, before attaching to the panel, install the
Box Module onto the Display Module or DC Power Supply Adapter for Box
Module.
• When installing the Box Module onto the Display Module or DC Power Supply
Adapter for Box Module, place the Display Module or DC Power Supply
Adapter for Box Module on a clean and level surface with the front screen
facing downward.
• Only qualified personnel can change the primary battery.
Failure to follow these instructions can result in equipment damage.
To Next Page
Loading...
