Pro-Form 120 R - Page 10

12. Orient the Shield Cover (12) as shown. Insert the
Wire Harness (53) upward through the Shield
Cover.
Slide the Shield Cover (12) onto the Upright (2).
Then, press the Shield Cover into the Right and
Left Shields (38, 39).
12
38, 39
13. While a second person holds the Handlebar (13)
near the Upright (2), insert the Wire Harness (53)
upward through the bracket on the Handlebar.
Tip: Avoid pinching the wires. Insert the
Handlebar (13) into the Upright (2). Attach the
Handlebar with three M8 x 16mm Screws (55);
start all of the Screws, and then tighten them.
13
Tip: Avoid
pinching the
wires
53
13
55
10