11
12
77
88
15
14
49
49
84
12. While a second person holds the Console (15)
near the Handlebar (14), plug the Main Wire
(77), the Extension Wire (88), and the Pulse
Wire (84) into the receptacles on the Console.
The connectors on the Wires (77, 84, 88)
should slide easily into the receptacles and
snap into place. If a connector does not slide
easily into a receptacle, turn the connector and
try again. If you do not connect the connectors
properly, the Console (15) may become dam-
aged when you use the exercise bike.
Insert the excess wire into the Handlebar (14).
Tip: Avoid pinching the wires. Attach the
Console (15) to the Handlebar (14) with four M4
x 16mm Screws (49). Start all the Screws, and
then tighten them.
Avoid pinching
the wires
13
13. Slide the Console Cover (16) upward against the
Handlebar (14). Attach the Console Cover with
two M4 x 16mm Screws (49).
14
49
16
To Next Page
Loading...
Need help?
General
