Pro-Form Fusion 6.0 LX - Page 10

13, Orient a Weight Guide (30) with the indicated
hoUecloser to the bottom, Attach the Weight
Guide to the Center Base (5) with an MIO x
65mm BoUt(110), two MIO Washers (109), a 1/2"
Spacer (68), and an MIO NyUon Locknut (111),
SHde a Weight Bumper (66) onto the Weight
Guide,
Attach the other three Weight Guides (30) to
the Center Base (5) in the same manner.
Tighten the MIO × 70ram Bolts (57) used in
step 3.
14, SHde eUeven Weights (34), with the pin grooves
on the bottom, onto a set of Weight Guides (30),
Orient a Weight Tube (75) as shown, Unsertthe
Weight Tube into the stack of Weights (34),
SHde another Weight (34) onto the set of Weight
Guides (30),
Repeat this step with the other stack of
Weights (34}.
13
Pin
Groove
10