Pro-Form Fusion 6.0 LX - Frame Assembly

Beforebeginningassembly,makesureyou
understandtheinformationin theboxon
sma!l parts, use the PAR]" mDENTmF!CATmON
CHART in the center of this manual
Attach the Foot Hate (90) to the Right Base (1)
with an M10 x 120mm BoUt(97), two M10
Washers (10% and an M10 NyUonLocknut (111),
Do not overtighten the Loeknut; the Foot Plate
must be able to pivot easily.
Unsertfour M10 x 80mm Carriage BoUts(112) up
through the Right Base (1), Hace a piece of tape
over the bout heads to hoUdthe BoUtsin pUace,
Unserttwo M10 x 80mm Carriage BoUts(112) up
through the Left Base (2), Hace a piece of tape
over the bout heads to hoUdthe BoUtsin place,
Attach the Center Base (5) to the Right and Left
Bases (1, 2) with four M10 x 70mm Bolts (57),
four M10 Washers (10% and two M10 Nylon
Locknuts (111), Do not tighten the Bolts yet.
9O
57
112
112
109
97
112
109
109
6