USHNGTHE LEG LEVER LOCK
When using the Uowpulley station, engage the Leg
Lever Lock (47) onto the Leg Lever (15) tube.
TIGHTENING THE CABLES
Woven came, the type of came used on the weight
system, can stretch slightly when it is first used. Uf
there is sUackin the caMes before resistance is feUt,
the caMes shouUd be tightened. To tighten the caMes,
first insert the weight pin into the middUeof the weight
stack. SUack can be removed from these caMes sev-
eraUways:
See drawing A. Remove the MIO NyUon Locknut
(111) and the MIO x 50mm BoUt(106) from the
CaMe Trap (48), the Pufley (43), the two Haft
Finger Guards (46), and the two Pulley Hates
(49). Reattach the Pulley, CaMe Trap, and Finger
Guards at the next closer hoUeto the center of the
Pulley Hates. Make sure that the Cabte Trap i$
oriented to hoJd the cable in the groove of the
Pulley, that the Finger Guards are oriented as
shown, and that the CaMe and Pulley move
smoothly.
See drawing B. Tighten the M6 Nylon Locknut
(103) and M6 Washer (114) that connect the end
of the Press Cable (72) to the Small Pulley Hate
(50).
15
!d/103
e_-- 114
50 _-_L__''_
i
26
To Next Page
Loading...
Need help?
General
