Pro Mach Orion SENTRY - Page 33

Orion Sentry by Orion
Revision 2.8 Semi-Automatic Stretch Wrapping Machine
27 August 2014 System Operation
Page 3-7
6. Press 1 to choose the number of top wraps to apply to the load.
7. Press SET to highlight the photocell delay timer. Use the up and down arrows or the
numeric keypad to enter the desired delay before the carriage stops moving up during
the automatic cycle. When done, press ENT.
8. Press SET to highlight the Top Wraps number. Use the up and down arrows or the
numeric keypad to enter the desired number of wraps applied to the top of the load
during the automatic cycle. When done, press ENT.
9. Press ESC to go back to the Select Parameter screen.
10. Press 2 to choose the number of bottom wraps to apply to the load.
11. Press SET to highlight the Bottom Wraps number. Use the up and down arrows or the
numeric keypad to enter the desired number of wraps applied to the bottom of the load
during the automatic cycle. When done, press ENT.
12. Press ESC to go back to the Select Parameter screen.
Figure 3 - 9
The Top Wrap
Modification Screen
Figure 3 - 10
The Bottom Wrap
Modification Screen