Sentry by Orion Orion
Semi-Automatic Stretch Wrapping Machine Revision 2.8
Troubleshooting 27 August 2014
Page 4-2
The Carriage Continues Too
Far Past the Top of the Load
• The photocell delay setting found on
the Top Wraps Modification Screen
is set too high.
• Decrease the photocell delay.
Continual Film Breakage
• Film tension is set too high.
• Bad or old film.
• Decrease the film tension
potentiometer knob.
• Replace the film spool.
Table 4-1. Troubleshooting Charts (Continued)
PROBLEM POSSIBLE CAUSE SOLUTION
To Next Page
Loading...
