ProCurve 2610 - Displaying 802.1 X Configuration, Statistics, and Counters; Show Commands for Port-Access Authenticator

Configuring Port-Based and User-Based Access Control (802.1X)
Displaying 802.1X Configuration, Statistics, and Counters
Displaying 802.1X Configuration,
Statistics, and Counters
802.1X Authentication Commands page 11-17
802.1X Supplicant Commands page 11-47
802.1X Open VLAN Mode Commands page 11-29
802.1X-Related Show Commands
show port-access authenticator below
show port-access supplicant page 11-57
Details of 802.1X Mode Status Listings page 11-54
RADIUS server configuration pages 11-25
Show Commands for Port-Access Authenticator
Syntax: show port-access authenticator
[config | statistics | session-counters | vlan] [< port-list >]
•Without [config | statistics | session-counters | vlan]
[<port-list >], displays whether port-access
authenticator is active (Yes or No) and the status of
all ports configured for 802.1X authentication.
•With <port-list> only, same as above, but only for the
specified ports. Does not display data for a specified
port that is not enabled as an authenticator.
•With [config | statistics | session-counters | vlan] [<port-
list >], displays the [config | statistics | session-counters]
data for the specified port(s). Does not display data
for a specified port that is not enabled as an
authenticator.
•With [config | statistics | session-counters | vlan] only,
displays the [config | statistics | session-counters] data
for all ports enabled as authenticators.
For more information on the [config | statistics | session-
counters | vlan] options, refer to the next section of this
table.
11-51