Web and MAC Authentication
Show Commands for MAC-Based Authentication
Syntax: show port-access [port-list] mac-based [config [auth-server]]
Shows MAC Authentication settings for all ports or the
specified ports, along with the Radius server specific
settings for the timeout wait, the number of timeout
failures before authentication fails, and the length of
time between authentication requests.
Syntax: show port-access port-list mac-based config detail
Shows all MAC Authentication settings, including the
Radius server specific settings for the specified ports.
Example: Verifying a MAC Authentication Configuration
The following example shows how to use the show port-access mac-based
config command display the currently configured MAC authentication settings
for all switch ports, including:
■ MAC address format
■ Authorized and unauthorized VLAN IDs
■ Controlled directions setting for transmitting Wake-on-LAN traffic on
egress ports
ProCurve(config)# show port-access mac-based config
Port Access MAC-Based Configuration
MAC Address Format : no-delimiter
Allow RADIUS-assigned dynamic (GVRP) VLANs [No] : No
Client Client Logoff Re-Auth Unauth Auth Cntrl
Port Enabled Limit Moves Period Period VLAN ID VLAN ID Dir
----- -------- ------ ------ --------- --------- -------- -------- -----
1 No 1 No 300 0 0 0 both
2 No 1 No 300 0 0 0 both
3 No 1 No 300 0 0 0 both
4 No 1 No 300 0 0 0 both
5 No 1 No 300 0 0 0 both
6 No 1 No 300 0 0 0 both
Figure 3-6. Example of Verifying a MAC Authentication Configuration
3-32
To Next Page
Loading...
