Need help?Do you have a question about the PRODEM PRB008 and is the answer not in the manual?
General| Brand | PRODEM |
|---|---|
| Model | PRB008 |
| Category | Power Tool |
| Language | English |
Explains the Safety Alert Symbol used in the manual.
Defines DANGER, WARNING, CAUTION, IMPORTANT signal words.
Provides fundamental safety guidelines for operation.
Outlines pre-operation checks and carrier compatibility.
Details critical safety rules during hammer operation.
Explains safety precautions for maintenance procedures.
Describes the standard warranty period for PRODEM hydraulic hammers.
Details warranty for sealing and wear parts.
Lists conditions under which warranty is voided.
Illustrates and lists main components of the hydraulic hammer.
Guides on model codes, serial numbers, and ordering parts.
Identifies key markings and labels on the hammer.
Details criteria for a compatible carrier for hammer installation.
Step-by-step guide for fitting the mounting adapter.
Instructions for safely mounting the hammer onto the carrier.
Procedures for connecting hydraulic hoses to the hammer.
Identifies and explains the function of various connection ports.
Steps for safely removing the hammer from the carrier.
Detailed instructions for installing and removing the chisel.
How to adjust the pressure-adjusting valve for blow power.
Guide to changing the impact rate between low and high speed.
Explanation and operation of the Auto-Stop function.
Checks to perform after the hammer is installed.
Guidance on choosing the correct chisel for different applications.
Best practices for operating the hammer for efficiency and longevity.
Basic rules and precautions for performing maintenance.
Defines regular maintenance intervals and tasks.
Recommendations for hydraulic oil type, viscosity, and temperature.
Instructions for lubricating the chisel and related parts.
Safety precautions and general information about gas charging.
Procedure for checking and refilling gas pressure in the back-head.
Procedure for checking and refilling gas pressure in the accumulator.
Details wear inspection and replacement of chisel and related parts.
Inspection and maintenance of the bracket and adapter.
Torque specifications for tightening various screws and bolts.
Procedure for checking and replacing through bolts.
How to inspect the piston bottom for wear or damage.
Instructions for storing the hammer for short and long periods.
To Next Page
