- 30 -
6.2. Correct working methods
Advance:
Move the impact point from the edge to the interior. Never try to
break off a too large block, if the
object has not broken within 30
seconds. The object should be broken up piece by piece in
small blocks. Large distance steps will not improve working
results.
Operating the hammer longer than 30 seconds may cause
damage to the hammer.
Angle of attack:
The hammer should always be positioned at
right angles to the surface of the material. If
the hammer is operated at slant angle,
The chisel slide off the material surface and it
cause blank blows that damage the hammer.
And the chisel will wear more quickly, or
broken more frequently.
Never use as a sledgehammer:
Before starting up, place the chisel point on the ground.
Never attempt to use the hammer as a sledgehammer to break material,
as the result of such action will cause damage to the hammer and the
carrier.
To Next Page
Loading...
