ENGLISH
Bedienungsanleitung/Instruction manual PRO800
28
In this case, the warranty expires as well. Machines will only be accepted for repair after
previous technical advice and written acknowledgement has been given.
Please do not enclose loose parts, e. g. portafilter or drip tray, when sending the machine in
for repairs / maintenance.
The steam nozzle is blocked
Clean the holes of the steam nozzle carefully with a needle or with a paper clip.
For this purpose, the steam nozzle may be unscrewed as well.
Important
Do not lose the small gasket situated between the steam nozzle and the thread!
Afterwards replace the steam nozzle.
8 TRANSPORT AND WAREHOUSING
8.1 Packing
The Pro800 is delivered in a special carton and protected by a plastic cover and foam.
Caution!
Keep packaging out of the reach of children!
Important
Keep packaging and packing material for possibile transport! Do not throw it away!
8.2 Transport
• Transport the machine only upright, if possible on a pallet.
• Do not tilt or turn the machine over.
• Do not stack more than three units on top of each other.
• Do not place other heavy items on the packing.
8.3 Warehousing
• Keep the machine packed in a dry place.
• Do not stack more than three units on top of each other.
• Do not place other heavy items on the packing.
• Do not expose the machine to the cold. Danger of damage.
9 DISPOSAL
WEEE Reg.-Nr.: DE 97592029
This product complies with EU Directive 2002/96/EC and is registered according to WEEE (Waste Electrical
and Electronic Equipment).
10 CE CONFORMITY
Conformity
The product complies with the following EU Directives:
Machine: 2006/42/EC
Low Voltage: 2014/55/EU
EMC: 2004/30/EU
PED: 97/23/EC
EN-Directives: EN 292-1, EN 292-2, EN 60335-1, EN 60335-2-15 or EN 60335-2-75,
EN 55014, EN 61000-3, EN 61000-4, ENV 50141, EN 55104
To Next Page
Loading...
