17
20
3
100
G
3
21. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of plastic
on the treadmill decals, remove the plastic. To protect the oor or carpet, place a mat under the treadmill. To
avoid damage to the console, keep the treadmill out of direct sunlight. Keep the included hex keys in a secure
place; one of the hex keys is used to adjust the walking belt (see pages 32 and 33). Note: Extra parts may be
included.
20. Press the two tabs on the Tablet Holder (100)
into the slots (N) in the console assembly (G).
Attach the Tablet Holder (100) with four M4 x
16mm Screws (3). Note: Start the two top
Screws rst, and then start the two bottom
Screws. Be careful not to overtighten the
Screws.
IMPORTANT: The Tablet Holder (100) is
designed for use with most full-size tablets.
Do not place any other electronic device or
object in the Tablet Holder.
Start First
N
To Next Page
Loading...
Need help?
General
